Creating a Raster Map for iGO Primo- To create a
Raster Map for iGO Primo needed
jpg images with coordinates tied
to the corners of the picture, with
step -binding
MUST be a
multiple of 0.125 degrees .
The size of each
single picture MUST be
equal to: 0.125 X 0.125 degrees. and in pixels of at least 2200 x 4096 ... (This
layer 16 in Google Earth ) Run the program
RasterNNG.exe1. enter the
town (In Primo will show only 12 characters)
2. MUST click on
OK (to continue after this
project with that name and
it will be open in the future by entering the same name in the box, city)
3. enter 3 characters
of the country 4. Open an image file (0.125 x 0.125 degrees) prepared for the screen
5. click
Calculate to calculate the pitch of the raster image to a block
6. click
Compile block raster paragraphs 4 and 6 to carry out as much as you have images (0.125 x 0.125 degrees) will go down in Raster Map ... 7. enter the coordinates
of the upper-left corner of the window display screen 8. enter the coordinates of the lower-right corner of the window display screen 9. Click
Calculate and fill in the coordinates (in the files and raster images will be calculated and filled with the coordinates for each block of the raster obtained in paragraph 6 of 10. enter in box files and raster images resulting *. rst files (lower part)
! WARNING! files entered in the order as shown in Figure
11. Click
Compile RASTER NNG and this compiler itself:
Raster_NNG.zip (806.11 KB)
Mirror Download : RASTER NNG Version 1.0 :
http://www.m...m/YHQMFGBOZP ... good luck
All credits goes to
PSBลองดูนะครับ